AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Remoter start milli amp draw12/29/2023 ![]() Then,ĭisconnect the main engine cable connection to the electrical block.ĭisconnect all add-on components wired directly to the battery or positive Disconnect the hot wire to theĪlternator to rule out diode backdraw in the alternator itself. If you are drawing too much current in the truck, my first steps would be toĬheck engine compartment components. Each should be checked independently from the other. Rewire the truck temporarily as two separate circuits, one to the winch and When you do a parasitic draw test in a dual battery system and you have an electric winch, you should ![]() I kept replacing batteries, with the problem much worse in the winter than ![]() It took awhile to figure it all out over several YEARS. If that doesn't reduce the draw, you need to look for a wire that is corroded or frayed. If the current drain is higher than that, you need to find out what is draining your batteries: You can start by pulling fuses until the load goes away.
0 Comments
Read More
Leave a Reply. |